Using Euroisdn Switches - Zoom ISDN TA/V.34 Owner's Manual

Special Instructions for Windows NT 4.0
In order for the HyperTerminal application to communicate successfully
with your ISDN board, you need to install a special Plug and Play
driver from your Windows NT installation CD-ROM disc.
You should have done this installation before installing the card in your
computer. See Chapter 2 for instructions on installing the driver.
Note Please follow these conventions when typing in these
commands.
Type the quotation marks (") shown.
Type the numbers indicated within brackets [ ]. Do not type the
brackets [ ] themselves.
For example:
If the phone company assigned your SPID2 as 0555200001, to enter this
you would type:
AT!C6"0555200001"
Follow this format for DN and switch types.

Using EuroISDN Switches

Restore factory defaults:
Switch type to National ISDN 1:
Set Directory numbers:
If you need to enter SubAddresses:
Note *S1 must be set to implement sub-addressing. Enter AT*S1.
Store settings and reset device:
56
AT&F
AT!C0=32 (This is the default)
AT!N1="[DN1]"
AT!N2="[DN2]"
AT!N1="[DN1] + [Subaddress]"
AT!N2="[DN2]" + [Subaddress]"
TA/V.34 and TA Owner' s Manual