Setting U P In Windows 3.1 Or 3.11 - Zoom ISDN TA/V.34 Owner's Manual

9. In Windows NT 4.0, you can test your TA/V.34 or TA as
follows:
Start your HyperTerminal application: Click on Start,
Accessories, HyperTerminal, Hypertrm. When the
Connection Description dialog box appears, type in any
name and press Enter. In the Phone Number dialog box,
click on the down arrow next to Connect using. Scroll down
to the Direct to Com x line, where x is the port setting for
your TA/V.34 or TA (see step 6 above). Press Enter. When
the next dialog box appears, press Enter again. You should
now be at HyperTerminal's main screen.
Type ATI3 (the third character is the letter 'I' and not the
numeral '1') and press Enter. If the name of your TA/V.34 or
TA is displayed, your ISDN card is properly set up.
Exit HyperTerminal, answering Yes to terminate the
connection and No when you are asked whether you want to
save the session.
10. Now install and set up your communications software. Follow
the instructions in the Quick Start guide or software user's
manual that came with the software.
If you need additional help in setting up and configuring your
communications software, see the section Tips for Selecting Setup
Options in the next chapter.
You may also want to review the section about Dial-Up Networking
using ML-PPP or PPP in Windows 95, which begins on page 28.
Setting Up in Windows 3.1 or 3.11
Your computer communicates through devices called ports. These are a
combination of physical connections and logical "addresses" that your
computer assigns to the ports. In addition, your computer uses
"interrupt requests," or IRQs, to keep port assignments from conflicting
with each other. Once your TA/V.34 or TA has been installed, it must
be assigned to a port.
Under Windows 95, port assignments and IRQs are usually taken care
of automatically by the Plug and Play feature. Under Windows 3.1 and
3.11, you must run a special batch file that will help your computer find
an available port.
20 TA/V.34 and TA Owner' s Manual