This will default to the entire length of the sequence, but you can set this to any range you wish. For example, to delete only the event in the first

bar from 2-bar sequence, set '001.01.00 - 002.01.00'. In this case, the event at 002.01.00 point will not be deleted.

If you set the end point '002.01.00' like this, the area right before the end point will be included in the area.

This will default to 'ALL EVENTS', but for this example, select NOTE ONLY.

The following are also available:

With CTRL CHANGE, POLY PRESS and REAL TIME you can be even more specific, selecting individual controller numbers or erasing poly

pressure events associated only with a certain note.

This field will default to PADS or NOTES, depending on the track type. ALL is selected in the 'Value' field as the default. While Pads is selected

on 'Parameter' field, you can select individual pads in the 'Value' field by hitting the specific pads you would like to delete directly. You can also

select a pad with the [DATA] Wheel.

If the selected track is a MIDI type track, instead of DRUM, this field will display

Notes as follows:

0(C -2) - 127(G 8)

The field for 'Notes' consists of two parts, Low note and High note. Low note (left)

sets lower range of MIDI note and High note (right) sets high range of MIDI note. In

this page, you can set note range with an external MIDI keyboard. The range is

updated whenever a MIDI note is received.

For example, when the MPC5000 receives only one note, such as C 3, the range is

set to C 3-C 3. When MPC5000 receive multiple notes, for example C 3, D 3 and E

3, then the range is set to C 3-E 3.

If you wish to delete all events, leave it as ALL. To delete only events on a specific

pad, hit the pad to delete. You can select several pads. If you hit a different pad by mistake, you can cancel the selection by hitting the pad again.

To restart the pad selection, turn the [DATA] wheel to the left. The value in the Note field will be reset to ALL so that you can select pad from the

beginning.