Storage - Trane IntelliPak SAHL Series Installation, Operation And Maintenance Manual

No Step Surface!
Do not walk on the sheet metal drain pan. Walking on the drain pan could cause the
supporting metal to collapse, resulting in the operator/technician to fall. Failure to follow this
recommendation could result in death or serious injury.
•
•
•

Storage

Take precautions to prevent condensate from forming inside the unit's electrical compartments and
motors if:
Note: Do not use the unit's heater for temporary heat without first completing the startup
Trane will not assume any responsibility for equipment damage resulting from condensate
accumulation on the unit's electrical and/or mechanical components.
RT-SVX36G-EN
If concealed damage is discovered, notify the carrier's terminal of damage immediately by
phone and by mail. Concealed damage must be reported within 15 days.
Request an immediate joint inspection of the damage by the carrier and the consignee. Do not
remove damaged material from the receiving location. Take photos of the damage, if possible.
The owner must provide reasonable evidence that the damage did not occur after delivery.
Remove the protective plastic coverings that shipped over the compressors.
a. the unit is stored before it is installed; or,
b. the unit is set on the roof curb, and temporary heat is provided in the building. Isolate all side
panel service entrances and base pan openings (e.g., conduit holes, S/A and R/A openings,
and flue openings) from the ambient air until the unit is ready for startup.
procedure detailed under "Starting the Unit" .
Warnings, Cautions and Notices
WARNING
5