Automation
Section 4 The Column Selector Module
4.1 Column Selector
Module Installation
4.1.1 Installing the Column
Selector Module
Removing the housing
from the EZ Prep
Figure 4-1 Location of the EZ Prep inner screw
Note
CombiFlash EZ Prep software must be version 3.1.0 or higher
to support the automation capabilities.
The Column Selector Module can be laid flat horizontally or
stood on an edge vertically for installation. If you are installing
the Column Selector Module horizontally, it is recommended that
you install the columns prior to continuing with the Column
Selector Module installation is recommended. If you are
installing the module vertically, install the columns after
installing the module.
To install the Column Selector Module vertically, please follow
the steps below.
1. Remove the screw connected to the housing from inside of
the EZ Prep using a #2 Phillips screwdriver.
4-1