Accessing Pump And Column Module Internal Connections; Removing The Column Module Back Plate - Teledyne 10 Installation And Operation Manual

Figure 2-2 Accessing pump and column module internal
connections
Figure 2-3 Removing the column module back plate
Pump Module
To complete the connections:
1. Release the two sets of tubes from the retaining clips (Fig-
ure 2-3).
2. Remove the four screws securing the back metal plate on
the column module (Figure 2-3). Then, lift and remove the
plate.
Screws
BioOptix™ 10
Section 2 Installation
Column Module
Screws
Retaining
Clips
2-3