Automation
Section 3 The AutoSampler Module
3.1 AutoSampler Module
Installation
3.1.1 Installing the
AutoSampler Module
Figure 3-1 AutoSampler Module rinse station
Note
CombiFlash EZ Prep software must be version 3.1.0 or higher
to support the automation capabilities.
Note
Begin your installation on a clean workspace separate from
the EZ Prep. You will be prompted to place the AutoSam-
pler Module on the right side of the EZ Prep in 3.1.2 Estab-
lishing Connections.
The AutoSampler Module includes the AutoInjector Module to
perform its automated functions. To install the AutoSampler
Module, follow the steps below:
1. Mount the rinse station by placing it into the receptacle
located on the right-rear portion of the AutoSampler Mod-
ule bed.
3-1