Table of Contents
Advertisement
Automation
Section 2 The AutoInjector Module
2.1 AutoInjector Module
Installation
Installation
Figure 2-1 Removing the top cover of the EZ Prep column
mount
Note
CombiFlash EZ Prep software must be version 3.1.0 or higher
to support the automation capabilities.
Note
If the AutoInjector Module is used in conjunction with the Col-
umn Selector Module, the standard prep column mount can
be removed to keep the overall system width minimized. In
this case, the AutoInjector Module can be mounted on top of
the Column Selector Module instead of on top of the standard
prep column mount.
1. Turn off the EZ Prep.
2. Remove the top cover of the EZ Prep column mount by
grasping and pulling straight up.
3. Remove the Luer fitting from the EZ Prep inject valve.
2-1
Advertisement
Table of Contents
