Table of Contents
Advertisement
Figure 2-14 Configuring the injection loop volume
2.2.2 Operation
For best results, the loop should generally be 50% filled for
maximum compound recovery. If the parameters entered for the
individual injection exceed a 50% loop fill, a warning message
will appear recommending a change in the parameters. This
warning can be ignored at the discretion of the user.
To use the AutoInjector Module, follow the steps below:
1. Place the sample probe into your sample container.
2. Press P
to start a separation as you would for an indi-
LAY
vidual separation.
3. If you want to automatically perform multiple injections
(or perform a single injection using the AutoInjector Mod-
ule), select the "Multiple Injections" drop down as shown in
Figure 2-15. This is the default selection if an AutoInjector
Module is present.
4. If you want to manually inject your sample without using
the AutoInjector Module, select "Load Now" or "Load After
Equilibrium". When prompted to load the sample, remove
the sample probe line from the inject valve and inject
directly into the valve.
Section 2 The AutoInjector Module
Automation
2-9
Advertisement
Table of Contents
