Table of Contents
Advertisement
Automation
Section 3 The AutoSampler Module
3.3 AutoSampler Module
Operation
3.3.1 Setup
Figure 3-38 Configuring the injection loop volume
3-20
The AutoSampler Module increases the fraction collection
capacity of the CombiFlash EZ Prep by two racks. The RFID
capabilities of these additional racks are supported in the same
way as the racks for the EZ Prep. When a rack is full, the system
will automatically advance to the next available rack. If a rack is
replaced with a fresh rack, this will be sensed by the system
software and the new rack will be made available for use. The
sample racks also have RFID tags which allow for the recognition
of vial locations.
Note
The sample rack cannot be swapped during a separation
sequence.
Before using the AutoSampler Module for the first time, the EZ
Prep should be configured for the proper injection loop volume.
1. Begin by going to T
2. Select the loop volume field as shown in Figure 3-38.
Note
The screen shot in Figure 3-38 depicts what is shown when a
Column Selector Module is installed. If the Column Selector
Module is not installed, this screen may appear differently.
| C
| P
OOLS
ONFIG
REP
HPLC.
Advertisement
Table of Contents
