Configuring The Input Level And Signal Format For Hdmi Inputs; Displaying A Black Picture On The Screen - Sony ZRD-C12A Operating Instructions Manual

Configuring the Input Level and
Signal Format for HDMI Inputs
1
Select [HDMI1] or [HDMI2] for [Input Select]
in the [Input Settings] screen, and click [OK]
or [Apply].
The video input changes.
2
Click [Common Input Settings].
The [Common Input Settings] screen
appears.
The settings configured on the primary
controller will be applied to all the other
Display Controllers, including the sub
controllers. Sub controllers cannot be
configured individually.
3
Configure each setting.
[Dynamic Range]: Select the video input
level for HDMI connectors 1 and 2.
• [Auto]: Determine the video input level
automatically.
• [Limited]: Select this when the video input
level is between 16 to 235.
• [Full]: Select this when the video input level
is between 0 to 255.
[HDMI Signal Format]: Select the video
signal format.
• [Enhanced Format]: Display pictures in a
higher definition HDMI format.
• [Standard Format]: Display pictures in a
standard HDMI format.
Caution
Select [Standard Format] when an input
device that does not support HDMI 2.0 is
connected.
4
When you are finished configuring
settings, click [Close].
Caution
The items in the [Common Input Settings] screen
cannot be configured when an input channel
other than HDMI is selected in [Input Select].
Displaying a Black Picture on the
Screen
When switching the video signals, use this
function when you do not want to display the
image at the moment of switching. Even when
displaying images from multiple Display
Controllers, all images are switched at the same
time.
Click [ON] in [Blank] on the main screen of
Display Control Software. If [OFF] is selected,
images from the video signal source will be
displayed.
Note
Set [Blank] to [ON] in standby mode, click [Power
ON] to display the black picture on the screen,
and start the system. After that, set [Blank] to
[OFF] to display the images.
14