Table of Contents
Advertisement
[3D Sync Signal Delay]: Use the slider or
buttons to adjust the phase (when 3D video
is not displayed properly). Moving the slider
also changes the number value. Clicking
[Reset] restores the default value.
Note
Inversion and phase adjustments can be
configured for both mixed L/R and separated L/
R. The settings are reflected in the picture
immediately after they are configured.
Synchronizing with
External Sync Signals
Inputting External Sync Signals
Input the external sync signal to the REF IN
(external sync signals input) connector on the
primary controller via a BNC cable.
Note
The following external sync signals are
supported.
• HD tri-level sync (0.6 Vp-p/75Ω/negative sync)
• SD black burst/composite sync (0.286 Vp-p/
75Ω/negative sync)
Enabling External Synchronization
Caution
If a primary controller is not configured with
Display Control Software or the primary
controller is not turned on, the external
synchronization cannot be enabled.
1
Select [Function] in the main screen of
Display Control Software, and then select
[System Settings].
2
Select [External Sync Signal] in [Sync Signal
Selection] under [Sync] in the [System
Settings] screen.
External synchronization is enabled
immediately.
18
Advertisement
Table of Contents
