3-2. Installation of the sewing machine
(1) Installing the under cover
❸
❶
1) The under cover should rest on the four corners
of the machine table groove.
❼
❽
3) Mount rubber hinge seats ❼ on the table and fix the
table with nails.
Insert hinge ❻ into the machine main body. Engage the hing-
es with rubber hinge seats ❼ mounted on the table. Then,
put the machine head down on the machine head cushions
❽ which are located at the four corners of the table.
5) Detach inlet port for circulation which is fixed on the feed box cover. Insert the inlet port into filter
until it will go no further without fail and place them in opening C.
Place urethan filter on D, and place filter of thin plate type (small mesh plate) on it.
Circulation trouble may occur unless inlet port for circulation is securely inserted into filer
until it goes no further.
22.5mm
❸
❶
❷
2) Fix two rubber seats ❶ on side A (operator's
side) using nails ❷ as illustrated above. Fix two
cushion seats ❸ on side B (hinged side) using a
rubber-based adhesive. Then place under cover
❹ on the fixed seats.
❻
– 5 –
❹
❶
A
B
❾
❻
❼
4) Attach head support rod ❾ to the table.
D
18.5mm
❸
C