❻
❸
❼
❹
❶
Table
❶ B
❽
❾
❹
❺
❻
Away from the
operator side
❷
❶ B
❶ A
Operator side
❹
❺
❻
– 15 –
2) Fix rubber cushion ❻ on control-box mounting plate
❸ with nut ❹ and spring washer ❼ . Three sets of
❷ are required.
3) Fix control-box mounting plates ❷ assembled
in step 2) on the table with decoration bolts ❶ ,
washers ❽ , spring washers ❾ and nuts .
Screw ❶ A at one location this side as observed
from the operator should be securely tightened,
and two screws ❶ B at two locations far side
from the operator should be temporarily tight-
ened.
* Install control-box mounting plate ❸ as illustrat-
ed in the figure, carefully checking the installing
direction and the location of holes.
* The washers, spring washers and nuts supplied
with the SC-920 should be used.
4) Place the SC-920 on rubber cushions ❻ and fix
with nuts ❹ and washers ❺ .
Install the control box while carefully changing the
position of the temporarily-fixed control-box mounting
plate (right one as observed from the worker).
1. If you use the decoration bolt supplied
with the SC-920, the control box cannot
be installed since the bolt interferes with
the control box.
2. If the control-box mounting plates are
fixed on the table in a wrong installing
direction or with the hole located at a
wrong position, the control box cannot
be installed.
❹
❺
❻
Away from the
operator side