6-11. Position of the wiper
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
❸
❺
❹
1) Adjust engraved marker dot ❶ on the machine arm to white marker dot ❷ on the handwheel.
2) Move rod ❸ in the direction of the arrow, and adjust with two clamping screws ❺ so that the clearance
between the top end of needle and wiper ❹ is approximately 2 mm.
6-12. Caution when installing the attachments
A
Needle
2mm
Be careful that screw A does not protrude in the
rear of the bed slide when fixing the attachment to
the bed slide with the screw.
When it protrudes as shown in the figure,
the screw interferes with other compo-
nents and break-down will be caused.
– 42 –
❷
❶