Using The Cooktop; Cooking Areas; Hot Surface Indicator; Using The Cooktop Elements - LG LUTE4619SN Service Manual

COOkING AREAS

The cooking areas on your range are identified by permanent circles on the
glass cooktop surface. For the most efficient cooking, fit the pan size to the
element size.
Pans should not extend more than
When a control is turned on, a glow can be seen through the glass cooktop
surface. The element cycles on and off to maintain the preset heat
setting, even on Hi.
SINGLE
BRIDGE
BRIDGE
NOTE:
• It is normal to see a very faint red ring around the outer edge of a dual
or triple element when using it as a single element at a high heat setting.
This is only a reflection from the bright glow of the center element and is
not a malfunction.
SINGLE

hOT SuRFACE INdICATOR

The hot surface indicator light glows as long as any surface cooking area
DUAL
is too hot to touch.
It remains on after the element is turned off and until the surface has
cooled to approximately 150 °F.
• It is normal for the surface elements to cycle on and off
during cooking, even on higher settings. This will happen
more frequently if cooking on a lower temperature setting.
uSING yOuR RANGE

uSING ThE COOkTOp

1 / to 1-inch beyond the cooking area.
2
WARM
SINGLE
SINGLE
ZONE
TRIPLE
DUAL
WARM
SINGLE
ZONE
SINGLE
CAUTION

uSING ThE COOkTOp ELEmENTS

• Only use cookware and dishes that are safe for oven and
cooktop use.
• Always use oven mitts when removing food from the cooktop
and oven.
• Do not place sealed containers on the cooktop.
• Do not use plastic wrap to cover food while on the cooktop.
WARM
SINGLE
ZONE
Plastic may melt onto the surface and be very difficult to
remove.
• Never leave food on the cooktop unattended. Spillovers
DUAL
can cause smoke. Greasy spillovers may catch on fire.
• The surface element may appear to have cooled after it has
been turned off. The element may still be hot and touching
the element before it has cooled sufficiently can cause burns.
Turning on a Single Element
1. Push the Single element knob in.
2. Turn the knob in either direction to the desired setting.
The control knob clicks when it is positioned at both Off and Hi.
Single
NOTE:
• Hi is the highest temperature available.
• Lo is the lowest temperature available.
2-3
CAUTION
Off On