Utility Package (Gx Configurator-Tc); Utility Package Functions - Mitsubishi Q Series User Manual

5 UTILITY PACKAGE (GX Configurator-TC)

5 UTILITY PACKAGE (GX Configurator-TC)

5.1 Utility Package Functions

Table 5.1 shows a list of the utility package functions.
Table 5.1 Utility Package (GX Configurator-TC) Function List
Function
(1) Make initial setting for Q64HLC channel-by-channel.
Set the values of the items which require initial setting.
•CH
•CH
•CH
•Cold junction temperature compensation
mode setting
•CH
•CH
•CH
•CH
•CH
•CH
•CH
•CH
•CH
•Alert dead band setting
•Alert delay count
Initial setting
•CH
time
•CH
band
•CH
•CH
•Approach band
•Soak time criteria
•CH
•PID continuation
•CH
•CH
•CH
•CH
•CH
•CH
(2) The initially set data are registered to the programmable controller CPU parameters, and when
the programmable controller CPU is set to the RUN mode, they are written to the Q62HLC.
5 - 1
Description
Input Range
Sensor compensation value setting
Primary delay digital filter setting
Unused Channel Setting
Upper Limit Setting Limiter
Lower Limit Setting Limiter
Setting Change rate Limiter
Upper output limiter
Lower output limiter
Output variation limiter
Alert 1 to 4 Mode Setting
Alert Setting Value 1 to 4
Loop disconnection detection judgment
Loop disconnection detection dead
Forward/Reverse Operation Setting
Control mode
Stop mode setting
AT bias
AT differential gap
AT additional lag
Set value (SV) setting
Proportional band (P) setting
Integral time (I) setting
•CH Derivative time (D) setting
•CH Control response parameter
•CH Program control RUN/RESET
•CH Execution pattern
•CH Start mode
•CH Time scale
•CH Zone 1 to 7 upper limit
•CH Zone 1 to 8 Proportional band (P)
setting
Integral time (I) setting
Derivative time (D) setting
Control response parameter
•CH Program pattern 1 to 3
Final segment
Pattern link
Iteration
Output time of pattern end
Wait zone
Segment 1 to 16
Set value (SV) setting
Executing time
Zone PID data No.
•Cascade bias
•Cascade gain
•CH Scaling range upper limit value
•CH Scaling range lower limit value
•CH Scaling width upper limit value
•CH Scaling width lower limit value
MELSEC-Q
Reference
section
5
Section 5.4
(To next page)
5 - 1