Procedure Before Starting The Operation - Mitsubishi Q Series User Manual

4 SETUP AND PROCEDURE BEFORE STARTING THE OPERATION

4.2 Procedure before Starting the Operation

The figure below shows the steps that should be followed before starting the Q62HLC
operation.
Module mounting
Mount the Q62HLC in the specified slot.
Wiring
Wire the Q62HLC.
Intelligent function module switch setting
Perform settings using the GX Developer
(see Section 4.5)
Execution of auto tuning
Perform auto tuning to set PID constants.
Use the GX Configurator-TC?
Initial setting
Using the FROM/TO commands, create
a sequence program for writing initial values.
Programming
Create and check a program using the
FROM/TO commands.
When executing temperature control as a temperature sensor, perform warmup
operation about 5 minutes before starting operation to make temperature
compensation properly.
4 - 2
Start
Yes
No
Operation
POINT
Initial setting
Perform the initial setting using the GX
Configurator-TC (see Section 5.4).
Perform auto
No
refresh setting?
Yes
Auto refresh setting
Perform the auto refresh setting using
the GX Configurator-TC (see Section 5.5).
Programming
Create and check a program without using the
FROM/TO commands.
MELSEC-Q
4
4 - 2