Execution Pattern Monitor (Buffer Memory Address 264, 520: Un\G264, Un\G520); Zone Pid Monitor (Buffer Memory Address 265, 521: Un\G265, Un\G521); Execution Pattern (Buffer Memory Address 272, 528: Un\G272, Un\G528) - Mitsubishi Q Series User Manual

3 SPECIFICATIONS

3.5.58 Execution pattern monitor (buffer memory address 264, 520: Un\G264, Un\G520)

3.5.59 Zone PID monitor (buffer memory address 265, 521: Un\G265, Un\G521)

3.5.60 Execution pattern (buffer memory address 272, 528: Un\G272, Un\G528)

3 - 87
(1) The program pattern No. in execution is stored in the program control.
• Pattern 1: 1 is stored.
• Pattern 2: 2 is stored.
• Pattern 3: 3 is stored.
(1) The zone No. of the zone PID data used for the control in the program control is
stored.
• Zone 1: 1 is stored.
• Zone 2: 2 is stored.
• Zone 3: 3 is stored.
• Zone 4: 4 is stored.
• Zone 5: 5 is stored.
• Zone 6: 6 is stored.
• Zone 7: 7 is stored.
• Zone 8: 8 is stored.
This setting is available only in the setting mode.
For confirming the change, it is needed to turn on the setting change command
(YnB).
(1) This setting specifies the program to be executed in the program control.
(2) The following shows the setting value.
• Program pattern 1: Set 1 (default value).
• Program pattern 2: Set 2.
• Program pattern 3: Set 3.
MELSEC-Q
3 - 87