Ip Address/Dhcp Settings - Hughes EchoStar Mobile 4500 User Manual

IP Address/DHCP Settings

Chapter 3 • Using the Web UI
16
H62751 Revision B
• Terminal Local IP Address – This section allows the user to change the
local IP address of the terminal from the default Ethernet IP address:
192.168.128.100. All four octets are available to change. Once the local IP
address is changed on this page and applied, the first 3 octets of the DHCP
address range will also change automatically.
• DHCP Server – Allows the DHCP server in the UT to be turned on or off by
checking the Enable box.
— DHCP Address Range – This allows the user to set the range of DHCP
addresses (from .101 to .199) that are given out by the UT to connected
TEs.
Updates to the Local IP address and DHCP server will not take effect until
the UT is rebooted .
• DHCP Reservations – This section allows the user to add an IP address
that will permanently be assigned to a particular connected device based
upon the detected device's MAC address.
Figure 6: IP Address/ DHCP screen