Connections - Hughes EchoStar Mobile 4500 User Manual

Connections

Chapter 3 • Using the Web UI
14
H62751 Revision B
Once connected to the network, the Terminal Status page will show that the UT
is registered with the network. In the middle of the Terminal Status page it will
show that the "Shared Connection" is established along with the TE's local IP
address.
For a basic connectivity, the Terminal would work with one signal bar. For more
details the user can look at the diagnostics page to see if the signal quality (SQI)
is at least 5dB. It is desirable to have 10dB or better.
The Connections page shows the status of the Shared Connection and the two
Custom Connections or Dedicated Connections. Each connection shows the
Local IP address associated with that connection and the Profile. It also shows
the Global IP address for active Custom connections.
• Shared Connection – This section shows the Connection status, the global
IP address and an Action button to disconnect the connection.
• Connected Devices Using the Shared Connection – This section shows the
local IP addresses of all devices connected to the Shared Connection.
• Dedicated Connection 1 and Dedicated Connection 2 – This section
shows the local IP, the APN Profile, the global IP address and an Action
button to disconnect the connection.
To start a Custom connection with the network, select one of the APN Profiles
from the drop-down menu and then click the Connect button. Once connected,
a global IP address will be populated and the Connect button will change to
Disconnect.
Figure 4: Connection page