Table of Contents
Advertisement
Chapter 3 • Using the Web UI
24
H62751 Revision B
• Port Triggering – This allows for outgoing traffic to automatically configure
port forwarding to the originating device. The port forwarding rule is
active for 120 seconds after the trigger event occurred.
The Port Triggering parameters to be configured are:
— Rule name
— Trigger Port
— Trigger Protocol
• TCP
• UDP
• TCP & UDP
— Incoming Ports to Open
— Incoming Protocol
— Rule Enabled
Figure 16: Port Triggering section
When the TE custom application opens "Trigger Port" X, then
— NAT sets up a translation rule for port X
— NAT adds translation rules for network-initiated connections to
"Incoming Ports" X1, X2, and X3 for a period of 120 seconds
Figure 17: Port Forwarding concept
Advertisement
Table of Contents
