Ip Address/Dhcp Settings - Hughes EchoStar Mobile 4500 User Manual

3.4.2 I P address/ DHCP settings
Terminal Local IP Address: This section allows the user to change the local IP address of the
•
terminal from the default Ethernet IP address: 192.168.128.100 . All four octets are available
to change. Once the local IP address is changed on this page and applied, the first three octets of
the DHCP address range will also change automatically.
DHCP Server: This allows the DHCP server in the UT to be turned on or off by checking the
•
Enable box.
DHCP Address Range: This allows the user to set the range of DHCP addresses (from .101 to
•
.199) that are given out by the UT to connected TEs. Changing the DHCP address range requires
an immediate reboot. The following IP addresses are reserved by the UT:
–
IP address of the terminal (e.g., 192.168.128.100 )
–
IP address just below (e.g., 192.168.128.099 )
Note: When updating the DHCP address range, the following settings will be updated or
reset and may need to be revisited:
– DHCP Address Range
–
DHCP Reservations
–
Port Forwarding
–
Port Triggering
–
Outbound Filters
• DHCP Reservations: This section allows the user to add an IP address that will permanently be
assigned to a particular connected device based on the detected device's MAC address.
Figure 7: Settings page
Chapter 3 • Using the Web UI
H62751 Revision C
19