Mounting The Acu-200, Acu-300, Acu-400 - Raymarine EVOLUTION EV-1 Installation Instructions Manual

Mounting the ACU-200, ACU-300, ACU-400

Important: The installation must only be performed with the vessel either on a hard standing, or
tied-up alongside a pontoon or berth.
1. Mount the ACU in an appropriate location and secure with the screws supplied.
You should also mount the autopilot control head and rudder angle reference sensor / transducer
(if appropriate) at this time.
2. Route the power, data and any other cables required for connection to the ACU.
3. Make all necessary connections into the ACU connector panel.
The connector panel is accessed by removing the front cover.
• A — Unlock cover panel
• B — Lock cover panel
Installation 55