Bracket Mounting The Ev-1 - Raymarine EVOLUTION EV-1 Installation Instructions Manual

1. Using the Mounting tray template (87170), drill 4 holes in the mounting surface, plus a 22 mm (7/8
in) hole for the SeaTalkng ® cable.
2. Place the small sealing ring in the groove located on the bottom of the Mounting tray.
3. Secure the tray to the mounting surface using the 4 x fixings, supplied.
4. Place the large sealing ring into the groove on the upper side of the Mounting tray.
5. Pull the SeaTalkng ® cable through the mounting surface hole and the Mounting tray. Plug in the
cable connector on the underside of the unit and secure by rotating the locking collar clockwise 2
clicks.
6. Insert the unit into the mounting tray, ensuring the tabs in the Mounting tray are slotted into the
grooves around the edge of the unit.
Important:
The unit must be mounted with the LED 'arrow' in parallel alignment with the longitudinal axis
(centerline) of the vessel and be pointing towards the vessel's bow.
7. Place the Mounting trim over the unit slightly offset, and then twist the Mounting trim clockwise
until it locks into position.

Bracket mounting the EV-1

The supplied Deck mounting kit is used to mount the unit on a vertical surface.
Ensure that the chosen location meets the product's location requirements; refer
to: p.42 — Location requirements — EV–1 and EV–2
Important: The installation must only be performed with the vessel either on a hard standing, or
tied-up alongside a pontoon or berth.
Installation 47