Table of Contents
Advertisement
10
Mounting the GyroPlus 2 unit
Fit the GyroPlus 2 unit to the vertical surface as follows:
1. Remove the outer cover (as shown below).
2. Temporarily hold the GyroPlus 2 unit in the required position so you
can mark the centers of the two fixing holes.
3. Use a 3 mm (
4. Screw one of the self-tapping screws provided (No 8 x 1 in) into each
hole, so each screw-head is at least 15 mm from the surface.
5. Place the fixing holes over the screw heads, then move the GyroPlus
2 unit down so the screw heads are at the top of the keyhole slots.
6. Tighten the screws to secure the GyroPlus 2 unit.
Note: Replace the outer cover after you have connected all cables.
Pathfinder Smart Heading System - Owner's Handbook
b
1
/
in) drill bit to make two pilot holes.
8
a
b
a
b
a
D5918-2
D5919-1
Hide quick links:
Advertisement
Table of Contents
