Releasing The Unit From The Bracket; Acu Installation; Mounting The Acu-100, Acu-150 - Raymarine EVOLUTION EV-1 Installation Instructions Manual

Releasing the unit from the bracket

Follow the steps below to release the unit from the Mounting bracket.
1. Insert the flat of a small flat blade screw driver, or similar tool into the release hole located on
the flat edge of the mounting bracket and twist the screw driver 90°, so that there is a small gap
between the Mounting trim and Mounting tray.
Important: To help prevent scratching the product, cover the tip of your screw driver with a small
piece of insulation tape.
2. With the screw driver in place, twist the mounting trim counter-clockwise approximately 10° and
then lift away from the unit.

8.2 ACU Installation

Mounting the ACU-100, ACU-150

Ensure that the chosen location meets the product's location requirements; refer
to: p.43 — Location requirements — ACU
Important:
The installation must only be performed with the vessel either on a hard standing, or tied-up
alongside a pontoon or berth.
1. Using an appropriate screwdriver, undo the screws located on the top cover and remove the top
cover from the ACU.
50