Husqvarna Automower 305 Technical Manual page 88

A1
Guide1
A2
If the LED is flashing yellow in test b) then
the break is somewhere in the boundary wire
between A1 and the position where the guide
wire is connected to the boundary wire (thick
black line in the illustration below).
A1
Guide1
A2
5. Put all connections back in their original
positions. Then disconnect A2. Connect a new
loop wire to A2. Connect the other end of this
new loop wire somewhere in the middle of the
installation. If the LED turns green then the
break is somewhere in the stretch between
the disconnected end and the position where
the new wire has been connected (thick black
line in the illustration below). If that is the case,
move the connection for the new wire closer
to the disconnected end (approximately in the
middle of the suspected stretch) and check
again whether the LED has turned green.
Continue until there is only a very short stretch
that makes the difference between a blue
flashing and a green solid light.
English - 86
6. TROUBLESHOOTING
3020-061
3020-062
A1
A2
A1
A2
A1
A2
6. When the break has been found, the
damaged part should be replaced with a
new wire. If it is possible to shorten the
boundary wire, the damaged part can be
cut away. Use only original couplers from
the Husqvarna Group.
3020-063
3020-064
3020-065
3018-055