Datamax I-Class Mark II Operator's Manual page 60

D I SPLAYED I TEM
TCP PRI NT
PORT
I NACTI VI TY
TI ME
LPD PRI NT
PORT
WI RELESS
ETHERNET
I P
DI SCOVERY
USE STATI C
ADDRESSES
USE DHCP
USE BOOTP
I P ADDRESS
SUBNET
MASK
DEFAULT
GATEWAY
HOST SETTI NGS
HOST TI MEOUT
10
Ch a pt e r 4 – M e n u Syst e m
Select s t he Port t o use for all TCP net work com m unicat ions; Default is 9100
Set t he am ount of t im e ( in seconds) in which t he current port will rem ain open
when no act ivit y is present .
Select s t he Port t o use for all LPD net work com m unicat ions; Default is 515
Cont rols t he com m unicat ions set t ings for t he wireless Et hernet net work int erface,
where:
Set s t he address discovery m et hod, where:
The st ored st at ic I P, Subnet Mask, and / or Gat eway Address will be used.
The card broadcast s over t he net work using DHCP prot ocol t o receive addresses
from t he responsible server at st art up. Manual m odificat ions t o I P Address, Subnet
Mask, or Gat eway Address are not allowed; and, if no server is found, t he specified
st at ic value will be used. ( Default Set t ing)

A server assigned I P address t akes precedence over any st at ic I P
address st ored in t he int erface.
The card broadcast s over t he net work using BOOTP prot ocol t o receive addresses
from t he responsible server at st art up. Manual m odificat ions t o I P Address, Subnet
Mask, or Gat eway Address are not allowed; and, if no server is found, t he specified
st at ic value will be used. ( Default Set t ing)

A server assigned I P address t akes precedence over any st at ic I P
address st ored in t he int erface.
Specifies t he st at ic I P Address of t he int erface in t he st andard oct et form at .
Specifies t he st at ic Subnet assigned t o t he int erface, for
exam ple: 255.255.255.000.
Specifies t he Gat eway Address t he int erface will use, for exam ple: 192.168.10.1
Cont rols t he com m unicat ions wit h a host device, where:
The " ignore host " set t ings for ESC SEQUENCES, HEAT, SPEED,

TOF SENSI NG, SYMBOL SET, CNTRL- CODES, STX- V SW
SETTI NGS, and MAX LENGTH will be unaffect ed when PL- Z Mode
is select ed ( see I nput Mode for det ails) .
Set s t he num ber of seconds ( 1 - 60) t hat an est ablished com m unicat ions port m ust
be idle before dat a can be received t hrough an alt ernat e port , where:

I f t he t im e- out period is exceeded before all dat a is received, t he
dat a will be ignored.
I s t he Default Set t ing.
I TEM D ESCRI PTI ON
5 4