Kenwood DMC-J7R Instruction Manual page 34

Check whether the total number of
tracks on the newly recorded MiniDisc
matches the total number of tracks on
the master MiniDisc. If they do not
match each other, combine or divide
tracks using the edit operation. (Pages
30-31)
This function can not be performed
from playback only MiniDisc.
2
When the recording is complete, remo-
ve the newly recorded MiniDisc and
load the master MiniDisc into the DMC-
J7R.
Do not mistake the master MiniDisc for
the newly recorded MiniDisc.
3
Whilst in the stop mode, press the
EDIT/AUTO MARK button to select
"NAME STAMP".
4
Press the ENTER/SYNC/F.PLAY but-
ton.
To cancel the operation, press the
/ OFF button.
3
5
Press the ENTER/SYNC/F.PLAY but-
ton.
The character information of the master
MiniDisc is being read.
6
When the unit displays "CHANGE MD",
remove the master MiniDisc.
Remove the master MiniDisc without
turning off the power. If you do, the
operation will be cancelled.
5
4
6
34
7
Load the newly recorded MiniDisc into
the DMC-J7R.
To cancel the operation, press the
/ OFF button.
8
Press the ENTER/SYNC/F.PLAY but-
ton.
The unit will finish recording the char-
acter information and enter the stop
mode.
Note:
If the total number of tracks on the mas-
ter MiniDisc does not match the total
number of tracks on the newly recorded
MiniDisc, the unit will display "Can't
WRITE" and the power will be turned
off.
If this happens, adjust the total number
of tracks on the newly recorded Mini-
Disc using the edit operation, and then
try again from step 2.