Kenwood DMC-J7R Instruction Manual page 14

To stop recording:
Press the / OFF button.
If the unit is left alone after the recor-
ding has stopped, the power will be
turned off about 2 minutes later.
After recording:
Press the / OFF button whilst in the stop
mode.
After the track number has been written
on the disc, the power will be turned off
Recording from a tuner or a CD (Manual recording)
Manual recordings can be started and stopped as you like.
1
Put the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the "Syn-
chro recording" section.)
2
Press the 38 button.
Recording will start.
To record from a CD, press the 38
button, and then start playback on the
equipment connected to this unit.
Track numbers can be created whilst
recording. (Page 20)
Recordings can not be made in the
following situations:
Recording on a playback-only Mini-
Disc (commercially available music)
If a Minidisc is protected against ac-
cidental erasure (page 12)
About the recording level:
If the recording level is too low, the
playback sound volume may be too
low to hear well. If it is too high, the
playback sound may be greatly dis-
torted. Since digitally recorded CDs
have a large dynamic range (the vo-
lume can vary tremendously from
very soft to extremely loud), do not
set the recording level any higher
than is necessary.
Precautions when recording:
Do not jar or bump the main unit
whilst recording. Otherwise, the re-
cording may be unusable.
automatically. (For details about the
TOC, see page 23.)
To remove the MiniDisc:
Turn off the power and move the EJECT
lever in the direction indicated by the ar-
row.
To interrupt recording:
Press the 38 button whilst recording.
The unit will enter the recording stand-
by mode.
To resume recording, press the 38
button again.
The track number will be increased by
one each time you interrupt a recor-
ding.
Depending on the strength and type
of playback signal in the original re-
cording, the new recording may not
begin or pause at the correct point
when in the synchro mode. If this
happens, try making a manual recor-
ding.
Precautions when inserting a Mini-
Disc:
To insert a Minidisc, push on the
middle of the edge of the disc whilst
holding it parallel to the main unit.
If any resistance is felt, do not try to
force the MiniDisc into the unit. It
may cause more problems. If resis-
tance is felt, remove the MiniDisc
and try reloading it.
Notes:
Whenever any button is pressed, the
remote control display will light for
about 4 seconds.
The RECORDING button does not
light.
14