Kenwood HM-383MD Instruction Manual page 32

32
Pause the recording
÷ Press the key again to resume recording. At this time,
the track number is incremented by "1". Recording
can also be started by pressing the MD rec key.
In regard to track numbers at the time of recording
When audio is input after a no-sound blank for more than 3 seconds during recording, the track number
is automatically incremented by "1". (The track number may sometimes not be incremented during re-
cording from TAPE or TUNER.) The track number may also be incremented when a pianissimo section
has continued during recording of classical music, etc. Remember that track numbers assigned auto-
matically by the unit can be deleted later.
The erroneously set track number can be erased later. When it is desired to increase the track No. during
recording, press the TRACK EDIT key during recording to record a track No. at that position.
The track numbers are used at the time of playback to find the start of tracks, for programming, etc.
Remote control unit only
Press during recording.
TRACK EDIT
÷ With digital recording from a CD, the track number is
increased when the track changes.
In regard to display messages
Recording is not possible when one of the following messages is displayed.
"DISC FULL" : The minidisc is full.
\ Erase unrequired tracks. YI
"PROTECTED" : The write protect tab is open.
\ Close it. l
"PLAY ONLY" : The minidisc is only for playback.
\ Insert a recordable disc.
MD
6
Stop the recording
÷ Do not turn power off or apply shock or impact while
"MD WRITING" is displayed. If the power cord is un-
plugged before "MD WRITING" disappears, the re-
corded or edited data will be lost.
÷ When the key is pressed during recording of CD, the
CD player is also stopped. When the key is pressed
during recording of tape, the tape deck is also
stopped. (Sync function)
When recording playback of CD, the track number
may sometimes be incremented by "1" at the mo-
Note Note
ment the CD starts to be played. This is due to the
signal included in the digital signal components
from the CD. To delete unnecessary track num-
bers, see "Erasing multiple tracks (QUICK
ERASE) or erasing all tracks in disc (ALL
ERASE)" or "Erasing
YI
(ERASE)".
Recording on MD
7
stop
Tuning
Mode
a single track