Storing The Machine In The Vertical-Stow Position - Toro Flex Force Power System 20361 Operator's Manual

Storing the Machine in the
Vertical-Stow Position
During the mowing season or in the off-season, you
can store your machine in the vertical position to
minimize storage space.
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 92 mm (3-5/8 inches) or lower; if it is
not, lower it; refer to
(page 12).
3. Disengage the handle locks
Figure 20
1. Handle lock disengaged
positions
4. Fold the handle fully forward.
Important:
Route the cables to the outside
of the handle knobs as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
Figure 21
Adjusting the Cutting Height
(Figure 20).
2. Handle lock engaged
position
(Figure 21).
g251558
g251559
18