Cleaning Under The Machine - Toro Flex Force Power System 20361 Operator's Manual

60v max 22in recycler lawn mower
Table of Contents

Advertisement

Available languages

Available languages

Figure 16
1. LED indicator light
2. Charger venting areas
5.
To remove the battery pack, slide the battery
backward out of the charger.
6.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator light
Off
Green blinking
Green
Red
Red blinking

Cleaning under the Machine

Service Interval: Before each use or daily
Cleaning under the Machine Using
the Washout Port
For best results, clean the machine soon after you
have completed mowing.
1.
Move the machine onto a flat paved surface.
2.
Shut off the motor and wait for all moving parts
to stop before leaving the operating position.
3.
Lower the machine to its lowest cutting-height
setting. Refer to
(page
12).
Indicates
No battery pack inserted
Battery pack is charging
Battery pack is charged
Battery pack and/or battery
charger is over or under the
appropriate temperature range
Battery pack charging fault
Adjusting the Cutting Height
4.
Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5.
Attach a garden hose that is connected to a
water supply to the washout port
g268087
1. Washout port
6.
Turn the water on.
7.
Start the motor and run it until the clippings no
longer come out from under the machine.
8.
Shut off the motor.
9.
Shut off the water and disconnect the garden
hose from the motor.
10.
Start the motor and run it for a few minutes to
dry the underside of the machine to prevent it
from rusting.
11.
Shut off the motor, remove the electric-start
button, and allow the it to cool before storing the
machine in an enclosed area.
Cleaning under the Machine in the
Vertical-Stow Position
1.
Set the machine in the vertical-stow position;
refer to
Storing the Machine in the Vertical-Stow
Position (page
2.
Wash out the clippings from under the machine.
16
(Figure
Figure 17
18).
17).
g251300

Advertisement

Table of Contents
loading

This manual is also suitable for:

Flex force power system 20361t

Table of Contents