Toro Super Recycler 20382 Operator's Manual

Toro Super Recycler 20382 Operator's Manual

Hide thumbs Also See for Super Recycler 20382:

Advertisement

Super Recycler
Model No. 20382—Serial No. 315000001 and Up

Introduction

Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Toro directly at www.Toro.com for product
and accessory information, help finding a dealer, or to register
your product.
Whenever you need service, genuine Toro parts, or additional
information, contact an Authorized Service Dealer or Toro
Customer Service and have the model and serial numbers of
your product ready.
Figure 1
model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety alert symbol
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
© 2014—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
identifies the location of the
G017490
Figure 1
(Figure
Register at www.Toro.com.
®
Lawn Mower
1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
This product contains a chemical or chemicals
known to the State of California to cause cancer,
birth defects, or reproductive harm.
The engine exhaust from this product
contains chemicals known to the State of
California to cause cancer, birth defects,
or other reproductive harm.
Important: This engine is not equipped with a spark
arrester muffler. It is a violation of California Public
Resource Code Section 4442 to use or operate the engine
on any forest-covered, brush-covered, or grass-covered
land. Other states or federal areas may have similar laws.
This spark ignition system complies with Canadian ICES-002.
The enclosed Engine Owner's Manual is supplied for
information regarding the US Environmental Protection
Agency (EPA) and the California Emission Control
Regulation of emission systems, maintenance, and
warranty. Replacements may be ordered through the
engine manufacturer.
Net Torque: The gross or net torque of this engine was
laboratory rated by the engine manufacturer in accordance
2),
with the Society of Automotive Engineers (SAE) J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine torque on this class of mower
will be significantly lower. Go to www.Toro.com to view
specifications on your mower model.
Form No. 3389-582 Rev A
Operator's Manual
Figure 2
WARNING
CALIFORNIA
Proposition 65 Warning
Original Instructions (EN)
All Rights Reserved *3389-582* A
Printed in the USA

Advertisement

Table of Contents
loading

Summary of Contents for Toro Super Recycler 20382

  • Page 1: Introduction

    You are responsible for operating the product properly and safely. This manual uses 2 words to highlight information. You may contact Toro directly at www.Toro.com for product Important calls attention to special mechanical information and accessory information, help finding a dealer, or to register and Note emphasizes general information worthy of special your product.
  • Page 2: Table Of Contents

    Contents Safety This lawn mower meets or exceeds the CPSC blade safety Introduction ..............1 requirements for walk-behind rotary lawn mowers at the time Safety ................2 of production. General Operation ..........2 Slope Operation ............3 Read and understand the contents of this manual before Children..............
  • Page 3: Slope Operation

    • • Never operate the machine in wet grass. Always be sure Never remove the fuel cap or add fuel with the engine of your footing; walk; never run. running. Allow the engine to cool before refueling. • Disengage the drive system, if so equipped, before •...
  • Page 4: Safety And Instructional Decals

    • Maintain or replace safety and instruction labels as genuine parts. When it comes to reliability, Toro delivers necessary. replacement parts designed to the exact engineering specifications of our equipment. For peace of mind, insist • To best protect your investment and maintain optimal on Toro genuine parts.
  • Page 5: Setup

    Setup 131–4514 Assembling and Unfolding the 1. Warning—read the Operator's Manual. Handle 2. Cutting/dismemberment hazard of hand or foot, mower blade—stay away from moving parts; keep all guards and shields in place. No Parts Required 3. Cutting/dismemberment hazard of hand or foot, mower blade—disconnect the spark-plug wire and read the Procedure instructions before servicing or performing maintenance.
  • Page 6: Installing The Recoil-Starter Rope

    Installing the Recoil-Starter Rope No Parts Required Procedure Important: To start the engine safely and easily whenever you use the machine, install the recoil-starter rope in the rope guide. Hold the blade-control bar to the upper handle and pull the recoil-starter rope through the rope guide on the handle (Figure G017479...
  • Page 7: Assembling The Grass Bag

    Assembling the Grass Bag No Parts Required Procedure 1. Slip the grass bag over the frame as shown in Figure G017491 Figure 6 3. Wipe off the dipstick end with a clean cloth. 4. Insert the dipstick into the oil-fill tube. 5.
  • Page 8: Product Overview

    Product Overview G027628 Figure 9 1. Cutting-height lever (4) 7. Recoil-start handle 2. Spark plug 8. Blade-control bar 3. Air filter 9. Adjustment knob for the self-propel drive 4. Oil fill/Dipstick (not shown) 10. Upper handle 5. Fuel-tank cap 11. Grass bag 6.
  • Page 9: Operation

    Operation 1 cm (1/2 inch) Filling the Fuel Tank DANGER Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the G027629 Figure 11 gasoline, place the container and/or machine directly on the ground before filling, not in a vehicle or on an object.
  • Page 10: Adjusting The Cutting Height

    excess oil, refer to Changing the Engine Oil (page 17). Important: If the oil level in the crankcase is too low or too high and you run the engine, you may damage the engine. 6. Install the dipstick securely. Adjusting the Cutting Height WARNING Adjusting the cutting height may bring you into contact with the moving blade, causing serious...
  • Page 11: Using The Self-Propel Drive

    Note: If the machine does not start, contact an Authorized Service Dealer. Using the Self-Propel Drive To operate the self-propel drive, simply walk with your hands on the upper handle and your elbows at your sides, and the machine will automatically keep pace with you (Figure 17).
  • Page 12: Bagging The Clippings

    G017464 Check the grass bag frequently. If it is damaged, Figure 22 install a new Toro replacement bag. 1. Discharge deflector 2. Rear-discharge plug If the side-discharge chute is on the machine, remove it and lock the side-discharge door; refer to Removing the 3.
  • Page 13: Side-Discharging The Clippings

    Removing the Grass Bag 1. Route the starter rope around the lower- rope guide (Figure 24). G017483 Figure 24 1. Lower-rope guide Note: The lower-rope guide releases the starter rope when you pull the recoil-start handle. 2. Raise and hold up the discharge deflector. 3.
  • Page 14: Operating Tips

    2. Lift open the side-discharge door (Figure 29). cutting season begins. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time. Do not cut below the 51 mm (2 inch) setting unless the grass is...
  • Page 15 • Mow only dry grass or leaves. Wet grass and leaves tend to clump on the yard and can cause the machine to plug or the engine to stall. WARNING Wet grass or leaves can cause serious injury if you slip and contact the blade. Mow only in dry conditions.
  • Page 16: Maintenance

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •...
  • Page 17: Changing The Engine Oil

    4. After draining the used oil, return the machine to the normal operating position. 5. Remove the dipstick and pour about 3/4 of the crankcase capacity of oil into the oil-fill tube. Note: Max. fill: 0.55 L (18.6 oz), type: SAE 30 or SAE 10W-30 detergent oil with an API service classification of SF, SG, SH, SJ, SL, or higher.
  • Page 18: Lubricating The Wheel Gears

    Lubricating the Wheel Gears Service Interval: Every 25 hours 1. Wipe the grease fittings just inside the rear wheels with a clean rag (Figure 37). Figure 37 1. Grease fitting 2. Install a grease gun onto each fitting and gently apply 2 or 3 pumps of #2 multi-purpose, lithium-based grease.
  • Page 19: Adjusting The Self-Propel Drive

    Adjusting the Self-Propel Drive Whenever you install a new self-propel cable or if the self-propel drive is out of adjustment, adjust the self-propel drive. 1. Turn the adjustment knob counterclockwise to loosen the cable adjustment (Figure 39). g027709 G017477 Figure 40 1.
  • Page 20: Storage

    Storage Store the machine in a cool, clean, dry place. Preparing the Machine for Storage WARNING Gasoline vapors can explode. • Do not store gasoline more than 30 days. • Do not store the machine in an enclosure near G017492 an open flame.
  • Page 21 Notes:...
  • Page 22 Notes:...
  • Page 23 Notes:...
  • Page 24: The Toro Total Coverage Guarantee

    Toro importer. If all other remedies fail, you may contact us at Toro Warranty Company. Australian Consumer Law: Australian customers will find details relating to the Australian Consumer Law either inside the box or at your local Toro Dealer.

Table of Contents