Storing The Machine In The Vertical-Stow Position - Toro Flex-Force Power System 20367T Operator's Manual

Storing the Machine in the
Vertical-Stow Position
You can store your machine in the vertical position to
minimize storage space.
WARNING
Folding or unfolding the handle improperly
can damage the cables, causing an unsafe
operating condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an
Authorized Service Dealer.
1. Remove the electric-start button and battery
from the machine.
2. Ensure that the cutting-height setting on the
machine is 44 mm (1-3/4 inches) or higher; if
it is not, raise it; refer to
Height (page 13).
3. Disengage the handle locks
Figure 16
4. Fold the handle fully forward.
Important:
Route the cables to the outside
of the handle locks as you fold the handle.
5. Engage the handle locks.
6. Lift the front of the machine by the handle and
move it into a storage space
Figure 17
Adjusting the Cutting
(Figure 16).
g297000
(Figure 17).
g297023
18