Commissioning; Overview - Theben Line coupler S KNX Manual

Line coupler S

Commissioning

3 Commissioning
The parameterization of the Line coupler S is undertaken using application program Couple Repeat/2,
Couple/1 or Repeat/1 and the Engineering Tool Software ETS.
The application program can be found at Theben AG/System components/...
For parameterization purposes, a PC or Laptop with ETS and a connection to the KNX, e.g. via RS232,
USB or IP interface, is required.
3.1

Overview

The following table provides an overview of the functions possible with the Line coupler S and the
application programs Couple Repeat 2.x (ETS 4) as well as Couple/1.x or Repeat/1.x (ETS 3).
Line/Area Coupler properties
Function Line/Area Coupler
Filter group telegrams main group 0...13
Filter group telegrams main group 14...31
Block physically addressed telegrams
Block broadcast telegrams
In case of errors repeat telegrams
Telegram confirmation
 = property applies
Repeater properties
Function Repeater
In case of errors repeat telegrams
 = property applies
Status: March 16 (Subject to change)
ETS 3 ETS 4
 
 



 
 
ETS 3 ETS 4
 
 
Page of
16 29