Using the Pattern Generator
To build an initialization sequence
To build an initialization sequence
Use the INIT SEQUENCE to place the system under test into a known
initialization state. Default start and end program vectors are marked INIT
SEQUENCE START and INIT SEQUENCE END. During a repetitive run, the
initialization sequence is only executed the first time the program is run. The
main sequence then loops repetitively.
From the Sequence menu, use the knob to highlight INIT SEQUENCE
1
START.
Select the Insert field once for each new line of vectors you want
2
inserted into the initialization sequence.
These new lines of vectors provide fields to place data into for each label.
Select the data field, then type in a data value.
3
If you are adding data in many fields, use the Autoroll feature. Refer to "To
use Autoroll" later in this chapter.
To edit a main or initialization sequence
Using the knob, highlight the vector you want to edit.
1
Select the data field you want to edit.
2
Select the new instruction or change the data value.
3
5–8