To Change The Trigger Specification - HP 1660CP Series User Manual

Using the Trigger Menu

To change the trigger specification

To change the trigger specification
Most triggers use terms other than "a." Even a simple trigger might use
additional terms to set conditions on the actual trigger. To use these terms,
you must include them in the trigger sequence specification.
In the Trigger menu, select the number beside the specific level you
1
want to modify.
A Sequence Level menu pops up. It shows the current specification for that
trigger level.
Select the field you want to change.
2
In the top row of the pop-up are three action fields: Insert Level, Select New
Macro, and Delete Level. The next section goes into detail on them. The
fields after "While storing", "TRIGGER on", and "Else on" are completed with
trigger terms. Selecting these fields pops up a menu of terms.
Select the term you want to use from the pop-up, or enter a new
3
value, as appropriate to the field.
Selecting "Combination" pops up a menu to define a term combination. The
combination mechanism is discussed in "Resource terms" in Chapter 8 and
"The Trigger Sequence" in Chapter 10.
If you have renamed a term, that name is automatically used everywhere the
term would appear.
Select Done until you are back at the Trigger menu.
4
Term Selection Pop-up Menu
4–6