Install The Ntbk50 Pri Card - Nortel Meridian 1 Option 11C Manual

Table 13
NTBK05CA pinouts
From:
50 pin MDF
connector
pin 23
pin 48
pin 24
pin 49

Install the NTBK50 PRI card

NTBK05CA pinouts
The pinouts for the NTBK05CA cable are as follows:
To:
Transmit coax
connector
Inner conductor
outer conductor
—
—
The NTBK50 serves as a motherboard to the NTAK20 clock controller, and
either the NTBK51 Downloadable D-channel handler or the NTAK93
D-channel handler.
The steps required to install PRI are as follows:
1 Inspect the PRI card and daughterboards
2 Set the switches on the PRI card
3 Mount the daughterboard(s) on the PRI card
4 Insert the PRI card in the main cabinet and any IP expansion cabinets
5 Connect the cables
Each of these steps is described in the pages that follow. The PRI hardware
installation procedure is the same regardless of the type of system at the far
end.
2.0 Mb PRI Implementation
To:
Receive coax
connector
—
—
Inner conductor
outer conductor
Option 11C
Page 47 of 126
To:
50 pin MDF
connector
—
—
—
—
2.0 Mb DTI/PRI