Baby Trend Cover Me CV89 Owner's Manual page 27

5.0 Installation and Use
5.9.1 Child Placement In The Car Seat Continued
8. Harness Covers, Head Pillow & Body
insert cont.
• DO NOT use head pillow if child's head
falls forward.
• DO NOT use head pillow above
shoulder position 3.
• ONLY use the body insert with children
who weigh between 4-18 lbs.
• Rear facing use only (Fig. 51a).
• Harness covers are required for
all harness modes expect for low
birthweight routing.
9. Insert the buckle tongues into the
buckle (Fig. 51b).
NOTE: Pull up and test buckle
tongues to be sure they are secure.
10. Place chest clip at arm pit level
(Fig. 51c). Insert chest clip tabs
and press together (Fig. 51d). Pull
outward on chest clip's ends to be
sure, it is secure.
51
Internal Harness Mode
Fig. 51a
Fig. 51b
Fig. 51c
Fig. 51d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
11. Pull on the harness tension adjuster
to tighten harness straps. The strap
should not allow any slack.The
strap should not press on to the
child's skin or push the child's body
into an unnatural position. Harness
Covers are required in all forward
facing and rear facing position
except the Low Birth weight
harness routing (Fig. 52a).
To Loosen Harness System
Tension, press the harness tension
adjuster button (Fig. 52b) located
underneath the seat fabric and
gently pull out on the harness
straps over the child's shoulder.
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig. 52a
Fig. 52b
52