Baby Trend Cover Me CV89 Owner's Manual page 22

5.0 Installation and Use
3. Remove body insert and head pillow and
store for later rear-facing use
(Fig. 41a).
4. Locate forward facing belt path openings
(Fig. 41b).
5. Loosen harness by pressing the center
Tension adjuster and pulling on harness
(Fig. 41c).
6. Lift seat fabric seat-back to expose the
forward-facing belt path (Fig. 41d).
NOTE: Remove any twist in webbing to
ensure the webbing lies for securing the
car seat to the vehicle.
(2)
(1)
Fig.41c
41
Internal Harness Mode
Body Insert Head Pillow
Fig. 41a
Fig. 41b
Fig. 41d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
7.Route Lap / Shoulder Belt
through the forward-facing belt
path. (Fig. 42a).
NOTE: Remove any twist in
webbing to ensure the webbing
lies for securing the car seat to
the vehicle.
8. Insert the lap/shoulder belt
buckle tongue into the buckle.
Place your hand or knee in the
seat and push down on the seat
while pulling up the lap/shoulder
belt to tighten (Fig. 42b). Pull
excess webbing at buckle tongue
to tighten.
9. Pull up on buckle as to ensure
the buckle is secure. Please refer
to the vehicle owner's manual
to determine if your vehicle lap/
shoulder belt includes a lockable
retractor and how to lock it.
10. Lower seat fabric seat-back and
press into position against the
seat back (Fig. 42c).
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig.42a
Fig.42b
Fig.42c
42