Baby Trend Cover Me CV89 Owner's Manual page 14

5.0 Installation and Use
3. Locate rear facing belt path openings
(Fig. 25a).
4. Remove both cup holders by pressing
the retention tab and set to the side
(Fig. 25b).
5. Pull the seat fabric back and route Lap
Belt through the rear facing belt paths.
NOTE: Remove any twist in webbing to
ensure the webbing lies flat for securing
the car seat to the vehicle
6. Insert the lap/shoulder belt buckle tongue
into the buckle. Place your hand in the
seat and push down on the seat while
pulling up the lap/shoulder belt to tighten
(Fig. 25d).
25
Internal Harness Mode
Fig. 25a
Fig. 25b
(Fig. 25c).
Fig. 25c
Fig. 25d
Copyright © 2020, Baby Trend, Inc.
5.0 Installation and Use
7. Pull up on buckle to ensure the
buckle is secure.
NOTE: Refer to the vehicle
owner's manual to determine if
your vehicle lap/shoulder belt
includes a lockable retractor and
how to lock it.
8. Reinstall the cup holders. Please
note LH or RH on bottom of
cupholder. LH or RH refers to
child's right and left (Fig. 26a).
9. Pull seat fabric back over each cup
holder (Fig. 26b), and then front of
seat to secure (Fig. 26c).
Copyright © 2020, Baby Trend, Inc.
Internal Harness Mode
Fig. 26a
Fig. 26b
Fig. 26c
26