Forward Facing Installation With Lap Belt And Top Tether - Baby Trend CV88 Owner's Manual

Installation and Use
5.0
4. Route auto belt through forward facing belt
path.
5. Put weight in seat with hand to compress
the automobile seat cushion then insert the
buckle tongue into the buckle and adjust seat
belt as tight as possible. Pull up on buckle
tongue to ensure the buckle is secure.
5. Lower flap and secure hook and loop
fasteners.
6. Attach Top Tether to a designated anchor
point. Pull Top Tether strap until webbing
strap is snug.
NOTE: Your vehicle owner's manual will
give the anchor locations and maximum
weight of the restraint's occupant for LATCH
connections.
7. Check for movement of the restraint at the
safety belt path. The restraint should not
move more than 1 inch in any direction. If the
restraint moves more than 1 inch repeat all
steps until all safety steps are met.
27
Copyright © 2015, Baby Trend, Inc.

5.6 Forward Facing Installation with Lap Belt and Top Tether

Requirements. See section 2.3:
Weight is 23 - 65 lbs (10.43 - 29 kg)
Height is 50 inches (127 cm) or less.
Age is 1 year old.
1. Place this restraint in a rear seating position. Always adjust the recline foot to
the upright position when forward facing.
2. Ensure vehicle is level and that the Convertible is placed flat, and rests on
the front outer edge of the vehicle seat.
3. Lift back flap and place harness to side.
Copyright © 2015, Baby Trend, Inc.
Installation and Use
5.0
Top Tether
28