Forward Facing Installation With Lap Belt And Top Tether - Baby Trend CV88A Owner's Manual

Hide thumbs Also See for CV88A:

Table of Contents

5.0 Installation and Use

5.6 Forward Facing Installation with Lap Belt and Top Tether

Requirements. See section 2.3:

Weight is 23 - 65 lbs (10.43 - 29 kg)

Height is 50 inches (127 cm) or less.

Age is 1 year old.

1. Ensure that the harness is adjusted to position 3

or 4. Only use recline positions 5 and 4 in forward

facing positions.

2. Ensure vehicle is level and that the Convertible is

placed flat, and rests on the front outer edge of the

vehicle seat.

3. Lift back flap and place harness to side.

Top Tether

Rear of Vehicle

5.0 Installation and Use

4. Route auto belt through forward facing belt

path.

5. Put weight in seat with hand to compress

the automobile seat cushion then insert the

buckle tongue into the buckle and adjust seat

belt as tight as possible. Pull up on buckle

tongue to ensure the buckle is secure.

5. Lower flap and secure hook and loop

fasteners.

6. Attach Top Tether to a designated anchor

point. Pull Top Tether strap until webbing

strap is snug.

NOTE: Your vehicle owner's manual will

give the anchor locations and maximum

weight of the restraint's occupant for LATCH

connections.

7. Check for movement of the restraint at the

safety belt path. The restraint should not

move more than 1 inch in any direction. If the

restraint moves more than 1 inch repeat all

steps until all safety steps are met.

Table of Contents