Maintenance Menu - Oki MC362w Maintenance Manual

Oki Data CONFIDENTIAL

5.1 Maintenance Menu

Service Menu
When the equipment is in standby mode, access the password entry screen by pressing [Setting] → [#] → [0] → [1] → [0] → [3] → [*].
Note! The initial Password is set to "000000" (six zeros).
Item1 Item2 Item3
Password
System OKIUSER
Mainte- *MPS mode:
nance MPS. Not
shown during
maintenance.
Format SD
Memory Card
*Shown only
when an
SD card is
connected
Format Flash
Memory
Reset Admin
Password
All Reset
*MPS mode:
MPS. Not
shown during
maintenance.
Test Print
Menu
44952001TH Rev.2
Item4 Item5 Value
************
ODA
OEL
APS
JP1
JPOEM1
OEMA
OEML
Execute
Execute
Execute
Execute
Enable
Disable
Default Default Default
value value value
ODA OEL JP
Enter the password for accessing the maintenance menu.
6 to 12 characters (numerals and lower-case alphabetic characters) may be entered.
Set the destination.
JPOEM1 : OEM for Japan
OEMA : OEM for overseas, with A4 as default size
OEML : OEM for overseas, with Letter as default size
Device reboots automatically after exiting the menu.
Displayed under the following conditions:
"System Maintenance"- When "OKIUSER" is other than JPOEM1, OEMA, or OEML,
and Manufacturer is "OKI DATA CORP"
Formats the SD card.
A confirmation message is displayed when the Enter switch is pressed.
When "No" has been selected, the system returns to the previous menu. When "Yes"
has been selected, the menu is exited and formatting of the inserted SD card begins.
Displayed under the following conditions:
SD card inserted ("Boot Menu" - "Storage Setup" - "Enable SD Card" is Yes)
Formats flash ROM memory.
When this command is executed, the menu is exited and formatting of the resident
(onboard) flash device begins.
Use of this command is strictly prohibited (contact design before use)
Returns the administrator password to the factory default value.
Returns the content of EEPROM, flash, and the HDD to their factory default values.
When this command is executed, the following confirmation message is displayed:
"This change will reboot the device automatically. Proceed?"
When "No" has been selected, the system returns to the previous menu. When "Yes"
has been selected, the menu is exited immediately and then, after rebooting, reset
processing begins.
See the "format scope" sheet for the scope of formatting.
Switches between displaying and not displaying the "ID Check" and "Engine
Information" in the "Report" - "Print Report" category (default: DISABLE). If this item is
set to "DISABLE," the "ID Check" and "Engine Information" will remain undisplayed at
all times.
The printer will reboot after changing the settings and exiting the menu.
5. MAINTENANCE MENUS
Notes
5-2