System Maintenance Mode (System Maintenance Menu) - Oki B431L6 Maintenance Manual

Oki Data CONFIDENTIAL

4.1.2 System maintenance mode (System maintenance menu)

Note!
• This mode is only used by maintenance personnel; it is not released to the end user.
• This mode is only B431.
• Refer to "Maintenance Utility" for B401/B411.
• (*1) can be set by "Maintenance Utility".
To open System Maintenance Menu, hold down the "MENU " and "MENU
switch. After the Category has been displayed, let go of the "MENU " and "MENU " button.
Category
OKIUSER
(*1)
MAINTENANCE
MENU
CONFIG MENU
TEST PRINT
MENU
FUSE KEEP
MODE
44983601TH Rev.1
Operation panel display
Setting item Setting item
(Upper case) (Lower case)
OKIUSER ODA
OEL
APS
JP1
JPOEM1
OEMA
OEML
FLASH FORMAT EXECUTE
MENU RESET EXECUTE
CODESET TYPE1
TYPE2
TEST PRINT ENABLE
MENU DISABLE
FUSE KEEP EXECUTE
MODE
" button and turn on the power
Default
* Only English is supported for panel
value
*
Set the destination.
JPOEM1: Japan Oriented OEM
OEMA: Overseas OEM for A4 default
OEML: Overseas OEM for Letter default
After passing the MENU, it reboots
automatically. If the Japanese font exist, JP1 is
default.
-
Initialize Flash ROM.
After executing it passes the MENU. The
format of Flash Device that is implemented on
resident (on board) starts.
-
Reset the EEPROM content to the (Factory
Default) setting value . After the setting
alteration, it reboots automatically.
Part of special item is not initialized.
*
This MENU displays as all destination.
TYPE1: Non display of Russian / Grace
TYPE2: Display Russian / Grace.
After passing the MENU, it reboots
automatically.
For destination of OEL/APS/OEMA, TYPE2 is
default value.
For other destinations, TYPE1 is default value.
Switch between whether to display ENGINE
*
INFORMATION that is on the INFORMATION
MENU Category of USER MENU. If this item is
Disable, ENGINE INFORMATION is not often
displayed.
-
While press ENTER Key the command is send
from CU to PU and then it becomes ONLINE.
Replace the consumable by the new one and
check the operation as the power ON. (At this
moment, the fuser of new consumable is not
cut and the operation count is not added to the
value of old consumable.
While turn the power OFF the check mode is
terminated.
Till the next time of power ON it is Disable.
4. ADJUSTMENT
Function
display
4-6 /