Adjustments; System Maintenance Menu - Oki C5100 Maintenance Manual

www.eManualpro.com
3.

ADJUSTMENTS

Adjustments on C5100 printers are made by operator panel key entry. In addition to a standard
menu, there is a maintenance menu in the display of their operator panels. The menu that serves
the purpose of intended adjustment is to be selected.
3.0

System Maintenance Menu

Turning on printer power while holding the MENU+ and MENU- keys down activates System
Maintenance menu. The menu is only displayed in English on a printer to any destination.
Note! System Maintenance menu, from which settings such as printer destinations can be
Category
OKIUSER
ENG STATUS
PRINT
PAGE CNT
PRINT
FUSE KEEP
MODE
NETWORK
ENGINE DIAG
MODE
The switch operation and LCD display during an engine self-diagnostic mode, which are specified
by engine firmware, differ from controller firmware operating specifications. The engine self-
diagnostic mode is enabled in a controller board removed configuration.
* Operation in such a configuration is not assured.
Refer to the engine block specification for C5100 for further details if necessary.
42049001TH Rev.1
changed, is hidden from users' view.
Table 3-0 Maintenance Menu Display Table
Operator Panel Display
Item (Upper Display) Value (Lower Display)
OKIUSER ODA
OEL
APS
JP1
JPOEM1
OEMA
OEML
ENG STATUS EXECUTE
PRINT
PAGE CNT ENABLE
PRINT DISABLE
PAGE KEEP EXECUTE
MODE
DF Function
Sets a destination.
* JPOEM1: Japan OEMs
OEMA: A4 default, Overseas OEMs
OEML: Letter default, Overseas OEMs
With the selection of a destination, printer rebooting is
performed.
Selected using the ENTER switch. Prints engine
information after initialization, at the press of the
ONLINE switch after the selection.
Sets whether to show the total number of pages on
* print menu map.
Places the printer online with the issue of a command
from the CU to the PU by the press of the ENTER
switch. While printer power is on, replace consum-
able part(s) with new one(s) and check printer
operation [without cutting the fuse(s) for the new
part(s) and without counting the operation on the
removed part(s)]. The check mode ends by turning
off the power, and is disabled at next turning-on of the
power.
Reserved for expansion. No item or value display is
provided at present.
Used to enter engine self-diagnostic mode.
Oki Data CONFIDENTIAL
40 /