Steps
1. Place the heat sink on the system board.
2. In sequential order (1>2>3>4) tighten the four captive screws that secure the heat sink to the system board.
NOTE:
The number of screws varies depending on the configuration ordered.
Next steps
1. Reconnect the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Fan
Removing the fan
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Disconnect the battery.
About this task
The following images indicate the location of the fan and provides a visual representation of the removal procedure.
40
Disassembly and reassembly
After working inside your
Before working inside your
computer.
computer.