Table of Contents
Advertisement
Steps
1. Align the slot on the memory module with the notch on the memory module slot on the system board.
2. Slide the memory module into the slot on the system board.
3. Press down on the memory module to snap it into place.
4. Ensure that the securing clips have locked the memory module into place.
NOTE:
If the securing clips are not locking the memory module into place remove the memory module from the slot and
repeat steps 1 to 3.
5. Repeat the procedure above for the second memory module.
Next steps
1. Reconnect the battery.
2. Install the
base
cover.
3. Install the
SD
card.
4. Follow the procedure in
Speakers
Removing the speakers
Prerequisites
1. Follow the procedure in
2. Remove the
SD
card.
3. Remove the
base
cover.
4. Disconnect the battery.
5. Remove the
M.2 2230 solid-state
6. Remove the
M.2 2280 solid-state
36
Disassembly and reassembly
After working inside your
Before working inside your
drive.
drive.
computer.
computer.
Advertisement
Table of Contents
